5PCS FEP Release Film for ELEGOO Mars LCD 3D Printer 140200 MM 0.15mm Thickness

My pack came with a small dent in all 5 sheets, but it prints fine.

I bought last film from seller and of course package arrived broken 💔 but after unpacking and installing all seems to work. Next time please put it also in bubble wrap otherwise if that is not handled with care product is useless....

There is a short video on how to replace these for my printer (AnyCubic Photon). A lot of screws but in the end it was very simple and took no more than 5 minutes. Clean everything off first and make sure you have a bottle cap from a soda or water, place it under the film as you're replacing it to create the tension on the first set of screws. Remove it when re-attaching to the VAT and it goes on nice and tight. Use a razor or x-acto knife around the inside edge to easily remove the excess and you're good to go. I tested a print almost immediately after that was an issue, I just re-zeroed the printer since it was slightly off and voila, back to perfect prints!

Fyller sin funktion till 100%!

Je l'emploi pour mon imprimante 3d elegoo.Rien à dire quand même assez epais.