AKOAFE 6PCS A4 Acrylic Sheet Clear Perspex Sheet 3mm Thick Plastic Sheet Acrylic Board for DIY, Craft, Protective Film, Glass Replacement, 29.7 x 21cm

My end use is making habitats for my ants. I needed some sheets of 3mm acrylic that I could be reasonably successful in cutting to A5, A6 and even A7 sizes.This works a treat.My preferred method of cutting is by scoring clamping and a sharp quick bend to snap the material, this behaves entirely to expectation, I have managed to get to A7 with a minimum of loss.The protective film is thick enough to do the job and remain one piece as you peel it off, it does what it's supposed to, the only interesting "quirk" I have noticed (and its not actually a bad one) is that while drilling (very slow drill, lubrication etc.) the material tends to melt on the drill tip rather readily, requiring stopping, picking the hard cap off the drill (3mm) before proceeding, the benefit of this is that the hole does not seem to propagate cracks (as seen with other material of this type and the finish of the hole is rather nice and clean, almost with a micro fillet, anyway , I digress.Does what I need it to do, delivered in sound condition, with an adequate protective film. Will buy again.

I thought these were OK. Did the job nicely and was worried that they would not be transparent but were. Cutting was easy using a bandsaw, size just what I needed and great value for money. Can tell not the best of quality but was perfect for what I needed.

Bought to produce some trophies using a laser cutter/engraver. It was important that the material was acrylic, however, the material sent was polystyrene which is completely unsuitable for laser cutting/engraving as its melting point is too low for detail work.

Used these as propogator sheets for some seeds. Did the job perfectly

ok

Ok

I bought this product for simplicity and speed of postage through Amazon. I wouldn’t buy again.The regular acrylic I buy cuts like butter with one pass, this took 3 and it was not a smooth cut, it stuck back on to itself and is not fit for purpose, also I am aware that laser cut acrylic comes with fumes but these were excessive and pungent. I’m really disappointed and would not recommend this product if you are looking to use with a laser cutter.

The acrylic sheets arrived damaged, scratched and protective wrapping ripped.